McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 286)

12
12-8 McDATA UltraNet Edge 3000 User Guide
Top Cover Installation Procedure
1. Turn off both power supplies on the UltraNet Edge 3000.
2. Unplug the power cords.
3. Locate the four screws on the top cover of the UltraNet Edge
3000.
4. Remove the four screws from the top cover using the small
Phillips screwdriver.
5. To remove the top cover, you must slide the cover towards the
rear of the unit as it is locked into the chassis.
6. Follow the Top Cover Installation Procedure to install the cover.
Top Cover Installation Procedure
Use the following procedure to install the top cover onto the UltraNet
Edge 3000.
Tools required: A small Phillips screwdriver and an adjustable
Torque driver, rated between 3 and 15 in-lbs.
Sb1
1
7