McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 403)

H-3
Update UltraNet ConfigManager with the Manual Configurations
NOTE: See the appropriate configuration chapter or the UltraNet
ConfigManager Tutorial for instructions on configuring your entire network
using UltraNet ConfigManager.
17. Once you have configured the entire network, follow the
procedure, “Update UltraNet ConfigManager with the Manual
Configurations” in this Appendix.
Update UltraNet ConfigManager with the Manual Configurations
It is necessary to update the UltraNet ConfigManager application
with the configuration information you entered manually. After
using UltraNet ConfigManager to configure the entire network, use
the following procedure to update the UltraNet ConfigManager with
the manual configurations.
1. Double-click the node you configured with the Command Line
Interface in the previous procedure.
2. Double-click the globe icon to bring up the Maintenance IP Port
form.
3. Enter the Maintenance Port IP Address and the Subnet Mask for
the node you configured manually with the Command Line
Interface.
Globe icon