McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 79)

5
Configuring an E_Port Extension over an Ethernet WAN 5-3
Configuring a 1x1 Ethernet Wide Area Network
• Default Gateway IP host address for the UltraNet Edge 3000
Ethernet Maintenance Interface
• UltraNet Edge 3000 Ethernet WAN Interface IP host address(es)
• Router IP host address (default gateway for the WAN data path)
attached to the UltraNet Edge 3000 Ethernet WAN Interface
For more detail on valid configuration options, see the “Valid
Hardware Interface Configurations” section in Chapter 2.
Starting UltraNet
ConfigManager Start the UltraNet ConfigManager application from either the icon
on your desktop or the Start menu. You have the option to use the
Online Tutorial when you first open the UltraNet ConfigManager
software. You can use either the Online Tutorial or this chapter of the
UltraNet Edge Storage Router 3000 Series User Guide to create a sample
network of a 1x1 Ethernet WAN. If you prefer to follow an example of
a 2x2 configuration, refer to the UltraNet ConfigManager Online Help.
Figure 5-2 UltraNet ConfigManager Main Window
Adding Nodes for
an Ethernet WAN
Configuration Use the following procedures to create a network map for a 1x1
Gigabit Ethernet WAN configuration. This configuration will have
two nodes that extend one Fibre Channel interface over one Gigabit
Ethernet WAN.
Tree
View
Area Network
Map View
Area