McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 251)

9
Configuring Tape Device Extension 9-43
Delivering the Configured Network
Note: If you used the “Manual Configuration of the Initial
IP Settings” procedure in Appendix H, complete the
“Update UltraNet ConfigManager with the Manual
Configurations” procedure before delivering the
configured network.
Setting the Delivery
Properties To set the properties for delivery of the network map configurations,
use the following procedure:
1. Right-click the desired node , then select Properties.
The Node10 Properties (UltraNet Edge 3000) screen appears,
where 1000 refers to the Edge model number.
2. Click on the drop-down menu to select the Delivery Interface.
The Delivery Interface defines the IP address by which the
network map will be delivered.
3. Select the desired option to deliver the network map
(configurations) to the node(s).
4. Click OK.
5. Repeat these steps for the other node(s).
6. Deliver the network map (configurations) by either the Delivery
Wizard or the Deliver Network option (below).
Delivery Wizard The Delivery Wizard delivers, activates, and resets the
configurations on selected node(s). Use the following procedure to
perform any of these functions on one or more node(s):
1. Click the File menu, then select Delivery Wizard.
The Delivery Wizard - Introduction screen appears.