McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 374)

D-2 UltraNet™ Edge Storage Router 3000 User Guide
Configuring the Internal McDATA Fibre Channel Switch Interface
FCSW Tab (2 port
only) If you are configuring the internal Fibre Channel Switch application
with two ports, an FCSW tab is selectable for each of the interface
ports. These tabs allow you to configure the parameters for each port.
From each of the FCSW tabs, select the Basic tab to configure the
basic parameters for each port and the Advanced tab to configure the
advanced parameters for each port.
If you are configuring the internal Fibre Channel Switch application
with one port, there are three tabs; the Basic tab, the Advanced tab,
and the FC Switch tab.
Basic Tab Select this tab to choose the I/O Port.
I/O Port
Select the I/O port from the drop-down list which displays all
available I/O ports. The currently selected port is highlighted.
Advanced Tab Select this tab to specify the Fibre Channel batching parameters.
If both Fibre Channel Switch interfaces have data paths configured,
the batching modifications made in this dialog box are only
applicable to this interface. The batching changes made to this
interface do not affect the peer Fibre Channel Switch interface.
FC Batching
Specify the Fibre Channel batching parameters in this area.