McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 142)

7
7-4 McDATA UltraNet Edge 3000 User Guide
Configuring a 1x1 ATM Wide Area Network
1. Select the Nodes tab located on the toolbar between the
TreeView Area and the Network Map Area (see Figure 7-2 on
page -3).
The Nodes tab displays three drop-down menus, containing the
node types for each available UltraNet Edge series.
2. Click the arrow next to the UltraNet Edge 3000 Series drop-down
menu and select the Edge 3000 (1x1 - ATM OC-3) node type.
The cursor will turn into crosshairs once you move the cursor
over the map area. The cursor must be crosshairs to complete the
current operation.
3. Click in the Network Map Area to create an instance of the
UltraNet Edge 3000 node.
Adding a Fibre Channel Interface
If this is the first time you are adding an Edge node to the
Network Map, the Default Fibre Channel Interface Type
drop-down list will appear. Select the type of Fibre Channel
interface for the network type you are configuring.
— The first time you see the Default Fibre Channel Interface
Type drop-down list, select the interface type you want as the
Fibre Channel I/F default. This sets the default that UltraNet
ConfigManager will use in each configuration. When
configuring an E_port extension over an ATM WAN, select
Fibre Channel (E_port)
.
Links tab
Interface tab
Nodes tab
UltraNet Edge 1000 Series
UltraNet Edge 3000 Series