McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 88)

5
5-12 McDATA UltraNet Edge 3000 User Guide
Configuring a 1x1 Ethernet Wide Area Network
3. Click the first node to create an IP circuit (in this example,
Node10).
This will cause “marching ants” to highlight the area around the
node icon, indicating that the node is in a special configuration
mode.
4. Click the second node (the destination that you want to connect
the circuit to).
The IP Circuit Wizard Introduction dialog box appears.
This wizard helps you select and configure an interface for each
node, and configure the circuit.
5. Click Next>.
The IP Circuit Wizard Node10 Choose Interface dialog box
appears.
The drop-down menu displays the available IP interface
providers in the UltraNet Edge 3000 for Node10.