McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 238)

9
9-30 McDATA UltraNet Edge 3000 User Guide
Configuring Tape Device Extension
Only the number of entries entered in this screen will be
automatically mapped. More will need to be added manually if
this number is not high enough (see the “Required Static Edge
LUN Mapping” section).
Selecting the Add Automatic Datapath Mapping Entries check
box, causes the Edge node 20 to become the target and node 10
the initiator. The Edge target connects to hosts and the Edge
initiator connects to tape devices. If both check boxes for node 10
and 20 are selected, both Edge nodes are targets and initiators.
NOTE: The number entered into the Number of New Entries field specifies
the maximum number of devices that can be automatically discovered and
mapped.
8. Click Next.
The FC Device Extension DataPath Wizard - Network Routing
Option
dialog box appears.
Dedicated Circuit is the only option available for a 1x1 Tape
Device Extension configuration.
9. Click Next.
Notes: