McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 87)

5
Configuring an E_Port Extension over an Ethernet WAN 5-11
Configuring a 1x1 Ethernet Wide Area Network
The License Wizard - Finish dialog box appears.
5. Click the Finish button to complete the configuration.
6. Right-click on Node 20 and then repeat step through step to set
the licensing information for this node.
7. Continue the configuration process by proceeding to the “Adding
an IP Circuit” procedure.
Adding an IP Circuit You will now create an IP circuit. A circuit is the IP WAN link
between Node10 and Node20. Use the IP Circuit Wizard to create and
configure the IP circuit by using the following procedure:
1. Select the Links tab on the center toolbar.
2. Click the IP icon on the center toolbar.
Links tab
IP icon (globe)