McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 119)

6
Configuring an F_Port Extension over an Ethernet WAN 6-13
Configuring a 2x2 Ethernet Wide Area Network
2. Click the IP icon on the center toolbar.
3. Click the first node to create an IP circuit (in this example,
Node10).
This will cause “marching ants” to highlight the area around the
node icon, indicating that the node is in a special configuration
mode.
4. Click the second node (the destination that you want to connect
the circuit to).
The IP Circuit Wizard Introduction dialog box appears.
Links tab
IP icon (globe)