McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 235)

9
Configuring Tape Device Extension 9-27
Configuring Tape Device Extension
1. In the main window of the UltraNet ConfigManager, right-click
on the Fibre Channel Device Extension interface 10 for
Node10 in the network map.
The Create Data Path menu is displayed.
2. Click the Create Data Paths selection. You should see “marching
ants” outlining the Fibre Channel Device Extension.
3. Double-click on the destination Fibre Channel Device Extension
interface 20 on Node 20 in the network map.
The FC Device Extension DataPath Wizard - Introduction dialog
box appears.
The FC Device Extension DataPath wizard collects information to
create data paths between selected interfaces.
Right-click on the FC interface
Double-click
FC interface