GE Industrial Solutions Pulsar Plus Controller - Manual (Page 134)

Pulsar Plus Controller Family
Issue 7 December 2011 134
require administrator level privilege. Thus, the password required is administrator. Similar responses are
seen when opening a Telnet session remotely over the LAN connection. Note: you have to give the path of
to the file in conjunction with the put commands.
Boot Block Software
Using any FTP client, perform the following steps to load Application Software:
1. Change your directory to the PC directory where the Application code is stored.
2. Type: FTP x.x.x.x ( The controller Working IP Address is 192.168.2.1).
ftp 192.168.2.1
Connected to 192.168.2.1
220 NE843 FTP Ready
3. Login as guest using the network administrator password (administrator).
User (192.168.2.1:(none)): guest
331 User name okay, need password
Password: administrator
230 Logged in
4. Change directory (cd) to the main boot block directory by typing: cd /.
ftp> cd /
250 CWD command successful
5. Use the put command to copy the application software to the controller.
ftp> put NE843-boot.bin
200 Port command okay
150 Opening data connection for STOR (192.168.2.1,1576)
6. Wait until the message indicating a successful file transfer is displayed.
226 File sent OK
ftp: 917504 bytes sent in 2.31Seconds 396.50Kbytes/sec.
7. Type bye to exit/logout of the FTP session.
ftp> bye
221 Goodbye!
Factory Defaults
Using any FTP client, perform the following steps to load default web pages:
1. Type: FTP x.x.x.x ( The controller Working IP Address is 192.168.2.1).
ftp 192.168.2.1
Connected to 192.168.2.1
220 NE843 FTP Ready
Code
Web
Defaults
Config