GE Industrial Solutions Pulsar Plus Controller - Manual (Page 155)

Pulsar Plus Controller Family
Issue 7 December 2011 155
Table 80 T1.317 Network Settings Related Commands
obj,attr Description sta cha ope type Range of Values
net1,des Description   text 30 char (Mid-String Voltage
Module n Channel c)
net1,ead Ethernet (MAC) Address  text hh:hh:hh:hh:hh:hh
net1,dhcp DHCP    number 0=static IP, 1=DHCP Client,
2=DHCP Server (OPE causes
system reboot)
net1,ip Static IP address   IP
address xxx.xxx.xxx.xxx (not used if
DHCP enabled)
net1,sub Static Subnet Mask   IP
address xxx.xxx.xxx.xxx (not used if
DHCP enabled)
net1,gtwy Static Gateway (Router) IP   IP
address xxx.xxx.xxx.xxx (not used if
DHCP enabled)
net1,host Hostname   text
net1,wip Working IP address  xxx.xxx.xxx.xxx (shows DHCP
assigned or static IP address)
net1,dom Static Domain Name   text (not used if DHCP enabled)
net1,dns Static DNS IP   IP
address xxx.xxx.xxx.xxx (not used if
DHCP enabled)
net1,wre Write Enable   0=disabled, 1=enabled
net1,tmo Session Timeout   Minutes
net1,msrv Mail host IP   IP
address xxx.xxx.xxx.xxx (0.0.0.0 will
force a DNS lookup of
“mailhost”)
Table 81 T1.317 Auxiliary Network Settings Related Commands
obj,attr Description sta cha ope type Range of Values
net2,des Description   text 30 char (Mid-String Voltage
Module n Channel c)
net2,ena Enable   number 0=disable 1=enable
net2,ip Static IP address   IP
address xxx.xxx.xxx.xxx (not used if
DHCP enabled)
net2,sub Static Subnet Mask   IP
address xxx.xxx.xxx.xxx (not used if
DHCP enabled)
net2,gtwy Static Gateway (Router) IP   IP
address xxx.xxx.xxx.xxx (not used if
DHCP enabled)
net2,host Hostname   text
net2,dom Static Domain Name   text (not used if DHCP enabled)
net2,msrv Mail host IP   IP
address xxx.xxx.xxx.xxx (0.0.0.0 will
force a DNS lookup of
“mailhost”)
net2 is currently only used by an attached Gateway Card in the NX400 system.