GE Industrial Solutions Pulsar Plus Controller - Manual (Page 29)

Pulsar Plus Controller Family
Issue 7 December 2011 29
Connect To the Controller
Connections to the controller are made through appropriate cable assemblies either directly to the main
board or automatically for direct backplane interconnects. The controller is designed with individual
connectors for outputs, inputs, communication, and other specific system related items. Primary system
interconnects are oriented at the top and right side edges of the NE843C/NE843E/NE843P door-mounted
units, on the left side of the unit’s NE843A/CP843A slot-mounted controllers, at the rear of the NE843G, and
at the front of the EP843D. The following information is valid for all configurations since the same main
microprocessor board is utilized in the different controller packages. Slight differences due to packaging will
be noted.
NE843C/NE843E/NE843P
NE843A/CP843A
NE843G
Many systems are shipped with the controller pre-wired in the factory. The following steps provides a brief
description of how and what to connect to the controller if these connections are to be made in the field.
Use only those that apply to the system configuration.