GE Industrial Solutions Pulsar Plus Controller - Manual (Page 72)

Pulsar Plus Controller Family
Issue 7 December 2011 72
Alarm Thresholds
Table 16 Alarm Thresholds Status
Float Voltage Alarms Shows the configured settings for the Float Settings: Very High Major (HVSD),
High Minor, Battery on Discharge (BD) and Very Low Voltage (VLV) alarms.
Values are shown in (xx.xxV) format.
Boost Voltage
Alarms Shows the configured settings for the Boost Settings: Very High Major (HVSD),
High Minor, and Battery on Discharge (BD) alarms. Values are shown in (xx.xxV)
format.
High Batt Temp Shows measured value of the highest battery temperature of all attached
QS873 battery thermal probes.
Reserve Low Shows configured value for the Low battery reserve time alarm.
High Ambient Temp Shows configured value for the High Ambient Temperature alarm. This
temperature is from the temperature sensor located on the controller itself.
Low Ambient Temp Shows configured value for the Low Ambient Temperature alarm. This
temperature is from the temperature sensor located on the controller itself.
Enabled/Disabled Info
This section of the menu provides a location to determine the Enable/Disable status of most controller
features.
Table 17 Enabled/Disabled Info Status
Temp Comp Shows whether Battery Temperature Compensation is Enabled or Disabled.
Low Temp Comp Shows if the Low Temperature compensation features is Enabled or Disabled.
Note: General temperature compensation must be Enabled to use Low
Temperature compensation.
Recharge Ilim Shows if the Recharge Current Limit feature is Enabled or Disabled.
Emrgncy Pwr Off Displays whether or not the Emergency Power Off (Remote Emergency Battery
Disconnect) feature is Enabled or Disabled. If Enabled, EPO is asserted when
contact closure is applied to the EPO input. The controller will keep battery
contactors open until this contact closure has been removed. The feature
assumes that AC has been removed to the system.
Critical=Major Shows if the assertion of the Critical alarm severity with all Major alarms
feature is Enabled or Disabled.
ACO Shows if Audible Alarm Cut-off feature is Enabled or Disabled.
Local Buzzer Shows if the on-board local audible buzzer is Enabled or Disabled.
Alarm Test Shows if the Form-C Alarm Test Feature is Enabled or Disabled.
Auto Boost Shows if the automatic boost charge mode of operation is Enabled or Disabled.
Auto Batt Test Shows if the automatic battery test feature is Enabled or Disabled.
Rect Redundancy Shows if the Rectifier redundancy feature is Enabled or Disabled.
Mid-Cell V Mon Shows if the Mid-String Voltage imbalance detection feature is Enabled or
Disabled.
Imminent Shutdn Shows if the Imminent system shutdown alarm (LVBD) feature is Enabled or
Disabled.