GE Industrial Solutions Pulsar Plus Controller - Manual (Page 25)

Pulsar Plus Controller Family
Issue 7 December 2011 25
Install and Configure Pulsar Plus NE843G Controller
Step Action
5 If an NE-872 Contactor Control Module is mounted on back of Door Mounted Controller remove
it to gain access to the jumpers. After removing the mounting screws carefully position the NE-
872 so that it is not in contact with electrically live components and is supported by the cables
connected to it. Otherwise continue.
NE-872 Contactor Control Module
6 Locate configuration jumpers for alarm relays as shown below.
Alarm Jumpers - Slot Controllers - Top of Controller
Alarm Jumpers - Door Mounted Controllers