Configuration prerequisites, Configuration procedure – H3C Technologies H3C S12500 Series Switches User Manual

Page 104

Advertising
background image

91

Figure 26 Rapid state transition of an RSTP designated port

If the upstream device is a third-party device, the rapid state transition implementation might be limited.
For example, when the upstream device uses a rapid transition mechanism similar to that of RSTP, and the

downstream device adopts MSTP and does not operate in RSTP mode, the root port on the downstream

device receives no agreement packet from the upstream device and sends no agreement packets to the

upstream device. As a result, the designated port of the upstream device fails to transit rapidly and can
only change to the forwarding state after a period twice the Forward Delay.
You can enable the No Agreement Check feature on the downstream device's port to enable the

designated port of the upstream device to transit its state rapidly.

Configuration prerequisites

Before you configure the No Agreement Check function, complete the following tasks:

Connect a device to a third-party upstream device supporting spanning tree protocols by using a
point-to-point link.

Configure the same region name, revision level and VLAN-to-instance mappings on the two devices,
assigning them to the same region.

Configuration procedure

To make the No Agreement Check feature take effect, enable it on the root port.
To configure No Agreement Check:

Step Command Remarks

1.

Enter system view.

system-view

N/A

2.

Enter interface view or port

group view.

Enter Ethernet interface view or Layer 2
aggregate interface view:

interface interface-type
interface-number

Enter port group view:

port-group manual port-group-name

Use either command.

3.

Enable No Agreement
Check.

stp no-agreement-check

By default, No Agreement
Check is disabled.

Root port

Designated port

Upstream device

Downstream device

(1) Proposal for rapid transition

(2) Agreement

The root port blocks non-edge
ports, changes to the forwarding
state, and sends an Agreement to
the upstream device.

The designated

port changes to the

forwarding state.

Advertising
This manual is related to the following products: