Configuration considerations, Configuration procedure – H3C Technologies H3C S12500 Series Switches User Manual
Page 37
24
Configuration considerations
To meet the requirements, you can configure IP subnet-based VLANs.
•
Create VLAN 10 and VLAN 20.
•
Assign users on subnet 1.1.1.0/24 to VLAN 10, and users on 2.1.1.0/24 to VLAN 20.
Configuration procedure
1.
Configure Switch:
# Create VLAN-interface 10 and VLAN-interface 20. (Details not shown.)
# Configure port GigabitEthernet 3/0/1 as a hybrid port to permit packets from VLANs 1, 10,
and 20 to pass through untagged, and configure the PVID of the port as 1.
[Switch] interface GigabitEthernet 3/0/1
[Switch-GigabitEthernet3/0/1] port link-type hybrid
[Switch-GigabitEthernet3/0/1] port hybrid vlan 10 20 1 untagged
Please wait... Done.
[Switch-GigabitEthernet3/0/1] port hybrid pvid vlan 1
# Configure ACL 3000 to permit packets from subnet 1.1.1.0/24 to pass through, and ACL 3001
to permit packets from subnet 2.1.1.0/24 to pass through.
[Switch] acl number 3000
[Switch-acl-adv-3000] rule 0 permit ip source 1.1.1.0 0.0.0.255
[Switch-acl-adv-3000] quit
[Switch] acl number 3001
[Switch-acl-adv-3001] rule 0 permit ip source 2.1.1.0 0.0.0.255
[Switch-acl-adv-3001] quit
# Configure a QoS policy named test to transmit ARP and IPv4 packets from subnet 1.1.1.0/24
through VLAN 10 and transmit ARP and IPv4 packets from subnet 2.1.1.0/24 through VLAN 20.
[Switch] traffic classifier 1
[Switch-classifier-1] if-match acl 3000
[Switch-classifier-1] quit
[Switch] traffic classifier 2
[Switch-classifier-2] if-match acl 3000
[Switch-classifier-2] if-match protocol arp
[Switch-classifier-2] quit
[Switch] traffic classifier 3
[Switch-classifier-3] if-match acl 3001
[Switch-classifier-3] quit
[Switch] traffic classifier 4
[Switch-classifier-4] if-match acl 3001
[Switch-classifier-4] if-match protocol arp
[Switch-classifier-4] quit
[Switch] traffic behavior 1
[Switch-behavior-1] remark service-vlan-id 10
[Switch-behavior-1] quit
[Switch] traffic behavior 2
[Switch-behavior-2] remark service-vlan-id 20
[Switch-behavior-2] quit
[Switch] qos policy test
[Switch-qospolicy-test] classifier 1 behavior 1