H3C Technologies H3C S12500 Series Switches - Manual (Page 23)

10
Step Command Remarks
5. Configure the PVID of the trunk
ports.
port trunk pvid vlan vlan-id
Optional.
By default, the PVID is
VLAN 1.
After configuring the PVID
for a trunk port, you must
use the port trunk permit
vlan command to
configure the trunk port to
allow packets from the
PVID to pass through, so
that the egress port can
forward packets from the
PVID.
Assigning a hybrid port to a VLAN
A hybrid port can carry multiple VLANs. You can assign it to a VLAN in interface view or port group
view.
To assign a hybrid port to one or multiple VLANs:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view or port
group view.
• Enter Ethernet interface view:
interface interface-type
interface-number
• Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
• Enter port group view:
port-group manual
port-group-name
N/A
3. Configure the link type of the
port as hybrid.
port link-type hybrid
By default, all ports are access
ports.
To change the link type of a port
from trunk to hybrid or vice versa,
you must set the link type to access
first.
4. Assign the hybrid port to the
specified VLANs.
port hybrid vlan vlan-id-list
{ tagged | untagged }
By default, the hybrid port is an
untagged member of the VLAN to
which the port belongs when its
link type is access.
Before assigning a hybrid port to a
VLAN, create the VLAN first.