Network requirements, Configuration procedure – H3C Technologies H3C S12500 Series Switches User Manual
Page 263
250
{
Ports GigabitEthernet 3/0/2 and GigabitEthernet 3/0/3 have learned only VLAN 1 through
MVRP.
Configuration example for MVRP in fixed registration mode
Network requirements
As shown in
, enable MVRP and set the MVRP registration mode to fixed on GigabitEthernet
3/0/1 on Device B, so that the dynamic VLANs on Device B are not deregistered.
Figure 88 Network diagram
Configuration procedure
1.
Configure Device A:
# Globally enable MVRP.
<DeviceA> system-view
[DeviceA] mvrp global enable
# Configure GigabitEthernet 3/0/1 as a trunk port, and configure it to permit all VLANs.
[DeviceA] interface GigabitEthernet 3/0/1
[DeviceA-GigabitEthernet3/0/1] port link-type trunk
[DeviceA-GigabitEthernet3/0/1] port trunk permit vlan all
# Enable MVRP on GigabitEthernet 3/0/1.
[DeviceA-GigabitEthernet3/0/1] mvrp enable
[DeviceA-GigabitEthernet3/0/1] quit
# Create VLAN 2.
[DeviceA] vlan 2
[DeviceA-vlan2] quit
2.
Configure Device B:
# Globally enable MVRP.
<DeviceB> system-view
[DeviceB] mvrp global enable
# Configure GigabitEthernet 3/0/1 as a trunk port, and configure it to permit all VLANs.
[DeviceB] interface GigabitEthernet 3/0/1
[DeviceB-GigabitEthernet3/0/1] port link-type trunk
[DeviceB-GigabitEthernet3/0/1] port trunk permit vlan all
# Enable MVRP on GigabitEthernet 3/0/1.
[DeviceB-GigabitEthernet3/0/1] mvrp enable
[DeviceB-GigabitEthernet3/0/1] quit
# Create VLAN 3.
[DeviceB] vlan 3
[DeviceB-vlan3] quit
3.
Verify the configuration: