H3C Technologies H3C S12500 Series Switches - Manual (Page 193)

180
GVRP fixed registration mode configuration example
Network requirements
As shown in Figure 63 , enable GVRP and configure the fixed registration mode on ports to enable the
registration of static VLAN information between the two switches.
Figure 63 Network diagram
Configuration procedure
1. Configure Device A:
# Enable GVRP globally.
<DeviceA> system-view
[DeviceA] gvrp
# Configure port GigabitEthernet 3/0/1 as a trunk port, and assign it to all VLANs.
[DeviceA] interface GigabitEthernet 3/0/1
[DeviceA-GigabitEthernet3/0/1] port link-type trunk
[DeviceA-GigabitEthernet3/0/1] port trunk permit vlan all
# Enable GVRP on GigabitEthernet 3/0/1 and set the GVRP registration mode to fixed on the
port.
[DeviceA-GigabitEthernet3/0/1] gvrp
[DeviceA-GigabitEthernet3/0/1] gvrp registration fixed
[DeviceA-GigabitEthernet3/0/1] quit
# Create VLAN 2 (a static VLAN).
[DeviceA] vlan 2
[DeviceA-vlan2] quit
2. Configure Device B:
# Enable GVRP globally.
<DeviceB> system-view
[DeviceB] gvrp
# Configure port GigabitEthernet 3/0/1 as a trunk port, and assign it to all VLANs.
[DeviceB] interface GigabitEthernet 3/0/1
[DeviceB-GigabitEthernet3/0/1] port link-type trunk
[DeviceB-GigabitEthernet3/0/1] port trunk permit vlan all
# Enable GVRP on GigabitEthernet 3/0/1, and set the GVRP registration mode to fixed on the
port.
[DeviceB-GigabitEthernet3/0/1] gvrp
[DeviceB-GigabitEthernet3/0/1] gvrp registration fixed
[DeviceB-GigabitEthernet3/0/1] quit
# Create VLAN 3 (a static VLAN).
[DeviceB] vlan 3
[DeviceB-vlan3] quit