H3C Technologies H3C S12500 Series Switches - Manual (Page 32)

19
Figure 8 Network diagram
Configuration consideration
Create VLANs 100 and 200. Associate VLAN 100 with IPv4, and VLAN 200 with IPv6. Configure
protocol-based VLANs to isolate IPv4 traffic and IPv6 traffic at Layer 2.
Configuration procedure
1. Configure Device:
# Create VLAN 100, and assign port GigabitEthernet 3/0/11 to VLAN 100.
<Device> system-view
[Device] vlan 100
[Device-vlan100] description protocol VLAN for IPv4
[Device-vlan100] port GigabitEthernet 3/0/11
# Create VLAN 200, and assign port GigabitEthernet 3/0/12 to VLAN 200.
[Device-vlan100] quit
[Device] vlan 200
[Device-vlan200] description protocol VLAN for IPv6
[Device-vlan200] port GigabitEthernet 3/0/12
# Create an IPv6 protocol template in the view of VLAN 200, and an IPv4 protocol template in the
view of VLAN 100.
[Device-vlan200] protocol-vlan 1 ipv6
[Device-vlan200] quit
[Device] vlan 100
[Device-vlan100] protocol-vlan 1 ipv4
[Device-vlan100] quit
# Configure port GigabitEthernet 3/0/1 as a hybrid port that forwards packets of VLANs 100
and 200 untagged.
[Device] interface gigabitethernet 3/0/1
[Device-GigabitEthernet3/0/1] port link-type hybrid