H3C Technologies H3C S12500 Series Switches - Manual (Page 168)

155
Step Command Remarks
3. Configure one behavior for a
CVLAN.
a. Create a traffic behavior and
enter traffic behavior view:
traffic behavior
behavior-name
b. Configure an SVLAN marking
action:
remark service-vlan-id
vlan-id-value
c. Return to system view:
quit
Repeat these steps to configure
a behavior for each CVLAN.
In one-to-one VLAN mapping,
the remark service-vlan-id
command is for marking both
the CVLAN and SVLAN tags,
because the switch uses the
command for marking the
outmost VLAN tag.
4. Create a QoS policy and
enter QoS policy view.
qos policy policy-name N/A
5. Associate the class with the
behavior to map the SVLAN
to the CVLAN.
classifier tcl-name behavior
behavior-name
N/A
Repeat these steps to create
other CVLAN-to-SVLAN
mappings.
Configuring the customer-side port
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter Ethernet interface view. interface interface-type
interface-number
N/A
3. Configure the link type of the
port.
port link-type { hybrid | trunk }
The default link type of an
Ethernet port is access.
4. Assign the port to the
CVLANs.
• As a hybrid port:
port hybrid vlan vlan-id-list tagged
• As a trunk port:
port trunk permit vlan { vlan-id-list |
all }
By default, ports of any link
type permit VLAN 1.
5. Apply the uplink policy to the
incoming traffic.
qos apply policy policy-name inbound N/A
6. Apply the downlink policy to
the outgoing traffic. qos apply policy policy-name
outbound
N/A
Configuring the network-side port
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter Ethernet interface view. interface interface-type
interface-number
N/A
3. Configure the link type of the
port.
port link-type { hybrid | trunk }
The default link type of ports is
access.