H3C Technologies H3C S7500E Series Switches - Manual (Page 237)

8-3
Task Remarks
Configuring MBGP Soft Reset Optional
Enabling the MBGP ORF Capability
Tuning and
Optimizing MBGP
Networks Configuring the Maximum Number of MBGP Routes for Load
Balancing
Optional
Configuring IPv4 MBGP Peer Groups Optional
Configuring MBGP Community Optional
Configuring a Large
Scale MBGP
Network
Configuring an MBGP Route Reflector Optional
Configuring MBGP Basic Functions
Prerequisites
Before configuring MBGP, make sure neighboring nodes can access each other at the network layer.
Configuration Procedure
Follow these steps to configure MBGP basic functions:
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number —
Specify a peer or peer group and
its AS number
peer { group-name | ip-address }
as-number as-number
Required
Not specified by default.
Enter IPv4 MBGP address family
view
ipv4-family multicast Required
Enable a peer or peer group
created in IPv4 unicast view
peer { group-name | ip-address }
enable
Required
Not enabled by default
Specify a preferred value for
routes from an IPv4 MBGP peer or
peer group
peer { group-name | ip-address }
preferred-value value
Optional
The default preferred value is 0.
Controlling Route Advertisement and Reception
Prerequisites
You need to configure MBGP basic functions before configuring this task.