H3C Technologies H3C S7500E Series Switches - Manual (Page 332)

12-12
To do… Use the command… Remarks
Enable MLD mld enable
Required
Disabled by default
For details about the multicast ipv6 routing-table command, see IPv6 Multicast Routing and
Forwarding Configuration Commands in the IP Multicast Command Reference.
Configuring the MLD Version
Because MLD message types and formats vary with MLD versions, the same MLD version should be
configured for all routers on the same subnet before MLD can work properly.
Configuring an MLD version globally
Follow these steps to configure an MLD version globally:
To do… Use the command… Remarks
Enter system view system-view —
Enter MLD view mld —
Configure an MLD version globally version version-number
Optional
MLDv1 by default
Configuring an MLD version on an interface
Follow these steps to configure an MLD version on an interface:
To do… Use the command… Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Configure an MLD version on the
interface
mld version version-number
Optional
MLDv1 by default
Configuring Static Joining
After an interface is configured as a static member of an IPv6 multicast group or an IPv6 multicast
source and group, it will act as a virtual member of the IPv6 multicast group to receive IPv6 multicast
data addressed to that IPv6 multicast group for the purpose of testing IPv6 multicast data forwarding.