H3C Technologies H3C S7500E Series Switches - Manual (Page 287)

9-31
Figure 9-5 Network diagram for static port configuration
Source
1::1/64
Router A
MLD querier
GE2/0/1
2001::1/64 GE2/0/2
1::2/64
Switch A
Switch C
Switch B
GE2/0/1
G
E
2
/0
/2
G
E
2
/0
/3
G
E
2
/0
1
GE2/0/2
G
E
2
/0
/1
GE2/0/2
Host C
Host B Host A
Receiver
Receiver
G
E
2
/0
/3
G
E
2
/0
/4
GE2/0/5
Configuration procedure
1) Enable IPv6 forwarding and configure IPv6 addresses
Enable IPv6 forwarding and configure an IPv6 address and prefix length for each interface as
per Figure 9-5 .
2) Configure Router A
# Enable IPv6 multicast routing, enable IPv6 PIM-DM on each interface, and enable MLD on
GigabitEthernet 2/0/1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface gigabitethernet 2/0/1
[RouterA-GigabitEthernet2/0/1] mld enable
[RouterA-GigabitEthernet2/0/1] pim ipv6 dm
[RouterA-GigabitEthernet2/0/1] quit
[RouterA] interface gigabitethernet 2/0/2
[RouterA-GigabitEthernet2/0/2] pim ipv6 dm
[RouterA-GigabitEthernet2/0/2] quit
3) Configure Switch A
# Enable MLD snooping globally.
<SwitchA> system-view
[SwitchA] mld-snooping
[SwitchA-mld-snooping] quit
# Create VLAN 100, assign GigabitEthernet 2/0/1 through GigabitEthernet 2/0/3 to this VLAN,
and enable MLD snooping in the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port gigabitethernet 2/0/1 to gigabitethernet 2/0/3
[SwitchA-vlan100] mld-snooping enable
[SwitchA-vlan100] quit
# Configure GigabitEthernet 2/0/3 to be a static router port.