H3C Technologies H3C S7500E Series Switches - Manual (Page 389)

13-38
IPv6 PIM Configuration Examples
IPv6 PIM-DM Configuration Example
Network requirements
z Receivers receive VOD information through multicast. The receiver groups of different
organizations form stub networks, and one or more receiver hosts exist in each stub
network. The entire IPv6 PIM domain operates in the dense mode.
z Host A and Host C are multicast receivers in two stub networks N1 and N2.
z Switch D connects to the network that comprises the multicast source (Source) through
VLAN-interface 300.
z Switch A connects to N1 through VLAN-interface 100, and to Switch D through
VLAN-interface 103.
z Switch B and Switch C connect to N2 through their respective VLAN-interface 200, and to
Switch D through VLAN-interface 101 and VLAN-interface 102 respectively.
z MLDv1 is to run between Switch A and N1, and between Switch B/Switch C and N2.
Figure 13-8 Network diagram for IPv6 PIM-DM configuration
Ether
net
Ether
net
Ethern
et
N1
N2
Vlan-
int10
2
Vlan-
int
102
Vl
an-
int1
03
Vl
an-
int
103
Device Interface IP address Device Interface IP address
Switch A Vlan-int100 1001::1/64 Switch D Vlan-int300 4001::1/64
Vlan-int103 1002::1/64 Vlan-int103 1002::2/64
Switch B Vlan-int200 2001::1/64 Vlan-int101 2002::2/64
Vlan-int101 2002::1/64 Vlan-int102 3001::2/64
Switch C Vlan-int200 2001::2/64
Vlan-int102 3001::1/64
Configuration procedure
1) Enable IPv6 forwarding and configure IPv6 addresses and IPv6 unicast routing