H3C Technologies H3C S7500E Series Switches - Manual (Page 333)

12-13
Follow these steps to configure a static member of an IPv6 multicast group or an IPv6 multicast source
and group:
To do… Use the command… Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Configure a static member of an
IPv6 multicast group or an IPv6
multicast source and group
mld static-group
ipv6-group-address [ source
ipv6-source-address ]
Required
By default, an interface is not a
static member of any IPv6
multicast group or IPv6 multicast
source and group.
Before you can configure an interface of an IPv6 PIM-SM device as a static member of an IPv6
multicast group or an IPv6 multicast source and group, if the interface is IPv6 PIM-SM enabled, it must
be an IPv6 PIM-SM DR; if this interface is MLD enabled but not IPv6 PIM-SM enabled, it must be an
MLD querier. For more information about IPv6 PIM-SM and a DR, refer to IPv6 PIM Configuration in
the IP Multicast Configuration Guide.
As a static member of an IPv6 multicast group or an IPv6 multicast source and group, an interface
does not respond to the queries from the MLD querier, nor does it send an unsolicited MLD
membership report or a MLD done message when it joins or leaves an IPv6 multicast group or an IPv6
source and group. In other words, the interface will not become a real member of the IPv6 multicast
group or the IPv6 multicast and source group.
Configuring an IPv6 Multicast Group Filter
To restrict the hosts on the network attached to an interface from joining certain IPv6 multicast groups,
you can set an IPv6 ACL rule on the interface so that the interface maintains only the IPv6 multicast
groups matching the criteria.
Follow these steps to configure an IPv6 multicast group filter:
To do… Use the command… Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—