H3C Technologies H3C S7500E Series Switches - Manual (Page 62)

2-30
Figure 2-5 Network diagram for static port configuration
Source
1.1.1.1/24
Router A
IGMP querier
GE2/0/1
10.1.1.1/24 GE2/0/2
1.1.1.2/24
Switch A
Switch C
Switch B
GE2/0/1
G
E
2
/0
/2
G
E
2
/0
/3
G
E
2
/0
/1
GE2/0/2
G
E
2
/0
/1
GE2/0/2
Host C
Host B Host A
Receiver
Receiver
G
E
2
/0
/3
G
E
2
/0
/4
GE2/0/5
Configuration procedure
1) Configure IP addresses
Configure an IP address and subnet mask for each interface as per Figure 2-5 . The detailed
configuration steps are omitted.
2) Configure Router A
# Enable IP multicast routing, enable PIM-DM on each interface, and enable IGMP on
GigabitEthernet 2/0/1.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface gigabitethernet 2/0/1
[RouterA-Gigabitethernet2/0/1] igmp enable
[RouterA-Gigabitethernet2/0/1] pim dm
[RouterA-Gigabitethernet2/0/1] quit
[RouterA] interface gigabitethernet 2/0/2
[RouterA-Gigabitethernet2/0/2] pim dm
[RouterA-Gigabitethernet2/0/2] quit
3) Configure Switch A
# Enable IGMP snooping globally.
<SwitchA> system-view
[SwitchA] igmp-snooping
[SwitchA-igmp-snooping] quit
# Create VLAN 100, assign GigabitEthernet 2/0/1 through GigabitEthernet 2/0/3 to this VLAN,
and enable IGMP snooping in the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port gigabitethernet 2/0/1 to gigabitethernet 2/0/3
[SwitchA-vlan100] igmp-snooping enable
[SwitchA-vlan100] quit
# Configure GigabitEthernet 2/0/3 to be a static router port.