H3C Technologies H3C S7500E Series Switches - Manual (Page 248)

8-14
To do… Use the command… Remarks
Enable BGP route refresh for a
peer/peer group
peer { group-name | ip-address }
capability-advertise
route-refresh
Optional
Enabled by default
If this feature is not enabled, you
need to configure this command.
For details about the command,
refer to BGP Configuration
Commands in the Layer 3 - IP
Routing Command Reference.
Enable the non-standard ORF
capability for a BGP peer/peer
group
peer { group-name | ipv6-address }
capability-advertise orf
non-standard
Optional
By default, standard BGP ORF
capability defined in RFC 5291
and RFC 5292 is supported.
If this feature is not enabled, you
need to configure this command.
For details about the command,
refer to BGP Configuration
Commands in the Layer 3 - IP
Routing Command Reference.
Enter MBGP address family view ipv4-family multicast —
Enable the ORF IP prefix
negotiation capability for a BGP
peer/peer group
peer { group-name | ip-address }
capability-advertise orf ip-prefix
{ both | receive | send }
Optional
Not supported by default
Table 8-1 Description of the both, send, and receive parameters and the negotiation result
Local parameter Peer parameter Negotiation result
receive
send
both
The ORF sending capability is enabled locally and
the ORF receiving capability is enabled on the
peer.
send
receive
both
The ORF receiving capability is enabled locally and
the ORF sending capability is enabled on the peer.
both both
Both the ORF sending and receiving capabilities
are enabled locally and on the peer, respectively.
Configuring the Maximum Number of MBGP Routes for Load Balancing
Follow these steps to configure the number of MBGP routes for load balancing: