H3C Technologies H3C S7500E Series Switches - Manual (Page 405)

14-3
Task Remarks
Configuring an IPv6 MBGP Peer Group Optional
Configuring IPv6 MBGP Community Optional
Configuring a Large Scale IPv6
MBGP Network
Configuring an IPv6 MBGP Route Reflector Optional
Configuring IPv6 MBGP Basic Functions
Configuration Prerequisites
IPv6 MBGP is an application of multi-protocol BGP. Therefore, before configuring IPv6 MBGP,
you need to
z Enable IPv6
z Configure network layer addresses for interfaces
z Complete BGP basic configuration
Configuring an IPv6 MBGP Peer
Follow these steps to configure an IPv6 MBGP peer
To do… Use the command… Remarks
Enter system view system-view —
Enable BGP and enter BGP
view
bgp as-number
Required
Not enabled by default
Enter IPv6 address family view ipv6-family —
Specify a IPv6 BGP peer and its
AS number
peer ipv6-address as-number
as-number
Required
Not configured by default
Enter IPv6 MBGP address
family view
ipv6-family multicast —
Enable the IPv6 MBGP peer peer ipv6-address enable
Required
Not enabled by default.
Configuring a Preferred Value for Routes from a Peer/Peer Group
Follow these steps to configure a preferred value for routes from a peer/peer group:
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number —