Digest snooping configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S5560 Series Switches User Manual
Page 129
95
To configure Digest Snooping:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter Layer 2 Ethernet or
aggregate interface view.
interface interface-type
interface-number
N/A
3.
Enable Digest Snooping on
the interface.
stp config-digest-snooping
By default, Digest Snooping is
disabled on ports.
4.
Return to system view.
quit
N/A
5.
Enable Digest Snooping
globally.
stp global config-digest-snooping
By default, Digest Snooping is
disabled globally.
Digest Snooping configuration example
Network requirements
As shown in
, Device A and Device B connect to Device C, which is a third-party device. All
these devices are in the same region.
Enable Digest Snooping on the ports of Device A and Device B that connect to Device C, so that the three
devices can communicate with one another.
Figure 26 Network diagram
Configuration procedure
# Enable Digest Snooping on GigabitEthernet 1/0/1 of Device A and enable global Digest Snooping
on Device A.
<DeviceA> system-view
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] stp config-digest-snooping
[DeviceA-GigabitEthernet1/0/1] quit
[DeviceA] stp global config-digest-snooping