H3C Technologies H3C S5560 Series Switches User Manual
Page 233
199
•
GigabitEthernet 1/0/1 has registered and propagated VLAN 10 and VLAN 20, and declared
VLAN 1 through MVRP.
•
Port GigabitEthernet 1/0/2 has registered VLAN 1, and declared and propagated no VLANs
through MVRP.
Verifying the configuration after changing the registration mode
When the network is stable, set the MVRP registration mode to fixed on the port of Device B connected
to Device A. Then, verify that dynamic VLANs on the port will not be deregistered.
# Set the MVRP registration mode to fixed on GigabitEthernet 1/0/3 of Device B.
[DeviceB] interface gigabitethernet 1/0/3
[DeviceB-GigabitEthernet1/0/3] mvrp registration fixed
[DeviceB-GigabitEthernet1/0/3] quit
# Display the local MVRP VLAN information on GigabitEthernet 1/0/3 of Device B.
[DeviceB] display mvrp running-status interface gigabitethernet 1/0/3
-------[MVRP Global Info]-------
Global Status : Enabled
Compliance-GVRP : False
----[GigabitEthernet1/0/3]----
Config Status : Enabled
Running Status : Enabled
Join Timer : 20 (centiseconds)
Leave Timer : 60 (centiseconds)
Periodic Timer : 100 (centiseconds)
LeaveAll Timer : 1000 (centiseconds)
Registration Type : Fixed
Registered VLANs :
1(default), 10
Declared VLANs :
20
Propagated VLANs :
10
The output shows that VLAN information on GigabitEthernet 1/0/3 is not changed after you set its MVRP
registration mode to fixed.
# Delete VLAN 10 on Device A.
[DeviceA] undo vlan 10
# Display the local MVRP VLAN information on GigabitEthernet 1/0/3 of Device B.
[DeviceB] display mvrp running-status interface gigabitethernet 1/0/3
-------[MVRP Global Info]-------
Global Status : Enabled
Compliance-GVRP : False
----[GigabitEthernet1/0/3]----
Config Status : Enabled
Running Status : Enabled
Join Timer : 20 (centiseconds)
Leave Timer : 60 (centiseconds)