H3C Technologies H3C S5560 Series Switches - Manual (Page 36)

2
Configuration procedure
To bulk configure interfaces:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface range
view.
• interface range { interface-type
interface-number [ to
interface-type
interface-number ] } &<1-24>
• interface range name name
[ interface { interface-type
interface-number [ to
interface-type
interface-number ] } &<1-24> ]
By using the interface range name
command, you assign a name to an
interface range and can specify this
name rather than the interface range to
enter the interface range view.
3. (Optional.) Display
commands available for
the first interface in the
interface range.
Enter a question mark (?) at the
interface range prompt.
N/A
4. Use available
commands to configure
the interfaces.
Available commands vary by
interface.
N/A
5. (Optional.) Verify the
configuration.
display this N/A
Displaying and maintaining bulk interface
configuration
Execute the display command in any view.
Task Command
Display information about the interface ranges that
are configured by using the interface range name
command. display interface range [ name name ]