Configuring a static aggregation group, Configuring a layer 2 static aggregation group – H3C Technologies H3C S5560 Series Switches User Manual
Page 65
31
Configuring a static aggregation group
To guarantee a successful static aggregation, make sure that the ports at both ends of each link are in the
same aggregation state.
Avoid assigning ports to a static aggregation group that has reached the limit on Selected ports. These
ports will be placed in the Unselected state to avoid traffic interruption on the current Selected ports.
However, a device reboot can cause the aggregation state of member ports to change.
Configuring a Layer 2 static aggregation group
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create a
Layer 2
aggregat
e
interface
and enter
Layer 2
aggregat
e
interface
view.
interface bridge-aggregation
interface-number
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
3.
Exit to
system
view.
quit
N/A
4.
Assign
an
interface
to the
specified
Layer 2
aggregat
ion
group.
a.
Enter
Layer 2
Ethernet
interface
view:
interface
interface-
type
interface-
number
b.
Assign
the
interface
to the
specified
Layer 2
aggregat
ion
group:
port
link-aggr
egation
group
number
Repeat these two sub-steps to
assign more Layer 2 Ethernet
interfaces to the aggregation
group.