Assigning a hybrid port to a vlan – H3C Technologies H3C S5560 Series Switches User Manual
Page 160
126
Step Command
Remarks
2.
Enter interface view.
•
Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
•
Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
•
The configuration made in
Layer 2 Ethernet interface view
applies only to the port.
•
The configuration made in
Layer 2 aggregate interface
view applies to the aggregate
interface and its aggregation
member ports. If the system fails
to apply the configuration to an
aggregation member port, it
skips the port and moves to the
next member port. If the system
fails to apply the configuration
to the aggregate interface, it
stops applying the
configuration to aggregation
member ports.
3.
Configure the link type of the
port as trunk.
port link-type trunk
By default, all ports are access
ports.
4.
Assign the trunk port to the
specified VLANs.
port trunk permit vlan { vlan-id-list
| all }
By default, a trunk port permits only
VLAN 1.
5.
(Optional.) Configure the
PVID of the trunk port.
port trunk pvid vlan vlan-id
The default setting is VLAN 1.
Assigning a hybrid port to a VLAN
A hybrid port supports multiple VLANs. You can assign it to the specified VLANs in interface view. Make
sure the VLANs have been created.
When you assign a hybrid port to a VLAN, follow these restrictions and guidelines:
•
To change the link type of a port from trunk to hybrid or vice versa, set the link type to access first.
•
To enable a hybrid port to transmit packets from its PVID, you must assign the hybrid port to the PVID
by using the port hybrid vlan command.
To assign a hybrid port to one or multiple VLANs:
Step Command
Remarks
1.
Enter system view.
system-view
N/A