Configuring a layer 3 dynamic aggregation group – H3C Technologies H3C S5560 Series Switches User Manual
Page 68
34
Step
Command
Remarks
6.
Assign
an
interface
to the
specified
Layer 2
aggregat
ion
group.
a.
Enter
Layer 2
Ethernet
interface
view:
interface
interface-
type
interface-
number
b.
Assign
the
interface
to the
specified
Layer 2
aggregat
ion
group:
port
link-aggr
egation
group
number
Repeat these two sub-steps to
assign more Layer 2 Ethernet
interfaces to the aggregation
group.
7.
Set the LACP operating
mode for the interface.
•
Set LACP to operate in passive
mode:
lacp mode passive
•
Set LACP to operate in active
mode:
undo lacp mode
By default, LACP is operating in
active mode.
8.
Configure the port
priority for the interface.
link-aggregation port-priority
port-priority
The default setting is 32768.
9.
Set the
short
LACP
timeout
interval
(3
seconds)
for the
interface.
lacp period short
By default, the long LACP timeout
interval (90 seconds) is adopted by
the interface. The peer sends
LACPDUs slowly.
Configuring a Layer 3 dynamic aggregation group
Step
Command
Remarks
1.
Enter system view.
system-view
N/A