H3C Technologies H3C S5560 Series Switches - Manual (Page 222)

188
Step Command Remarks
5. Configure the trunk port to
permit the specified VLANs. port trunk permit vlan { vlan-id-list
| all }
By default, a trunk port permits only
VLAN 1.
Make sure the trunk port permits all
registered VLANs.
For more information about the
port trunk permit vlan command,
see Layer 2 — LAN Switching
Command Reference.
6. Enable MVRP on the port. mvrp enable
By default, MVRP is disabled on a
port.
Configuring an MVRP registration mode
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
interface interface-type
interface-number
N/A
3. Configure an MVRP
registration mode.
mvrp registration { fixed |
forbidden | normal }
Optional.
The default setting is normal
registration mode.
Configuring MRP timers
To avoid frequent VLAN registrations and deregistrations, use the same MRP timers throughout the
network.
Each port maintains its own Periodic, Join, and LeaveAll timers, and each attribute of a port maintains a
Leave timer.
To configure MRP timers:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
interface interface-type
interface-number
N/A
3. Configure the LeaveAll timer. mrp timer leaveall timer-value
Optional.
The default setting is 1000
centiseconds.