Displaying and maintaining qinq, Qinq configuration examples, Basic qinq configuration example – H3C Technologies H3C S5560 Series Switches User Manual
Page 241: Network requirements
207
Step Command
Remarks
14.
Apply the QoS policy to the
inbound direction of the
port.
qos apply policy policy-name inbound
N/A
For more information about QoS policies, see ACL and QoS Configuration Guide.
Displaying and maintaining QinQ
Execute display commands in any view.
Task
Command
Display QinQ-enabled ports.
display qinq [ interface interface-type
interface-number ]
QinQ configuration examples
Basic QinQ configuration example
Network requirements
As shown in
:
•
The service provider assigns VLAN 100 to Company A's VLANs 10 through 70.
•
The service provider assigns VLAN 200 to Company B's VLANs 30 through 90.
•
The devices between PE 1 and PE 2 in the service provider network use a TPID value of 0x8200.
Configure QinQ on PE 1 and PE 2 to transmit traffic in VLANs 100 and 200 for Company A and
Company B, respectively.
For the QinQ frames to be identified correctly, set the SVLAN TPID to 0x8200 on the service provider-side
ports of PE 1 and PE 2.