H3C Technologies H3C S5560 Series Switches User Manual
Page 77
43
Figure 11 Load sharing for multiswitch link aggregation in an IRF fabric
To enable local-first load sharing for link aggregation:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable
local-first
load
sharing
for link
aggregat
ion.
link-aggregation load-sharing
mode local-first
By default, local-first load sharing
for link aggregation is enabled.
Configuring per-flow load sharing algorithm settings for
Ethernet link aggregation
Configure the per-flow load sharing algorithm and algorithm seed to optimize traffic distribution on
aggregate links based on existing per-flow load sharing settings. You can set only the algorithm or the
algorithm seed, or both. You can combine an algorithm with different algorithm seeds to obtain different
effects.
This feature does not take effect on per-flow load sharing that uses the following traffic classification
criteria:
•
Source IP address.
•
Destination IP address.
•
Source MAC address.
•
Destination MAC address.
Any Selected ports on the
ingress switch?
Local-first load sharing
mechanism enabled?
Yes
No
Yes
No
The egress port for a traffic flow is an
aggregate interface that has Selected
ports on different IRF member switches
Packets are load shared only
across the Selected ports on the
ingress switch
Packets are load shared across
all Selected ports