Enabling arp snooping, Configuring the customer-side port, Configuring the network-side port – H3C Technologies H3C S5560 Series Switches User Manual
Page 256
222
Tasks at a glance
(Required.) Configuring the network-side port
Enabling ARP snooping
Enable ARP snooping for the original VLANs and the translated VLANs.
To enable ARP snooping:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter VLAN view.
vlan vlan-id N/A
3.
Enable ARP snooping.
arp snooping enable
By default, ARP snooping is disabled.
For more information about ARP
snooping commands, see Layer 3—IP
Services Command Reference.
Configuring the customer-side port
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter Layer 2 Ethernet
interface view.
interface interface-type
interface-number
N/A
3.
Set the link type of the port.
•
Configure the port as a trunk
port:
port link-type trunk
•
Configure the port as a hybrid
port:
port link-type hybrid
By default, the link type of a port is
access.
4.
Assign the port to the original
VLANs and the translated
VLANs.
•
port trunk permit vlan
vlan-id-list
•
port hybrid vlan vlan-id-list
tagged
N/A
5.
Configure a many-to-one
VLAN mapping.
vlan mapping uni { range
vlan-range-list | single vlan-id-list }
translated-vlan vlan-id
By default, no VLAN mapping is
configured on an interface.
Configuring the network-side port
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
•
Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
•
Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
N/A