Configuring a layer 3 static aggregation group, Configuring a dynamic aggregation group, Configuring a layer 2 dynamic aggregation group – H3C Technologies H3C S5560 Series Switches User Manual
Page 66
32
Configuring a Layer 3 static aggregation group
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create a
Layer 3
aggregat
e
interface
and enter
Layer 3
aggregat
e
interface
view.
interface route-aggregation
interface-number
When you create a Layer 3
aggregate interface, the system
automatically creates a Layer 3
static aggregation group
numbered the same.
3.
Exit to
system
view.
quit
N/A
4.
Assign
an
interface
to the
specified
Layer 3
aggregat
ion
group.
a.
Enter Layer 3 Ethernet
interface view:
interface interface-type
interface-number
b.
Assign
the
interface
to the
specified
Layer 3
aggregat
ion
group:
port
link-aggr
egation
group
number
Repeat these two sub-steps to
assign more Layer 3 Ethernet
interfaces to the aggregation
group.
Configuring a dynamic aggregation group
To guarantee a successful dynamic aggregation, make sure that the peer ports of the ports aggregated
at one end are also aggregated. The two ends can automatically negotiate the aggregation state of each
member port.
Configuring a Layer 2 dynamic aggregation group
Step
Command
Remarks
1.
Enter system view.
system-view
N/A