H3C Technologies H3C S5560 Series Switches - Manual (Page 304)

270
LAN switching LLDP-MED trapping
configuration, 249
LLDP frame encapsulation format, 247
LLDP frame format, 234
LLDP frame reception, 239
LLDP frame transmission, 239
LLDPDU management address TLV, 238
LLDPDU TLV types, 235
LLDPDU TLVs, 235
management address configuration, 245
management address encoding format, 245
operating mode (disable), 238
operating mode (Rx), 238
operating mode (Tx), 238
operating mode (TxRx), 238
operating mode set, 242
parameter set, 246
polling enable, 242
protocols and standards, 239
reinitialization delay, 242
trapping configuration, 249
voice VLAN CDP advertisement
configuration, 177
voice VLAN information advertisement to IP
phones, 169
voice VLAN IP phone identification
method,
168 , 169
voice VLAN LLDP advertisement
configuration,
177
voice VLAN LLDP enable, 176
LLDP frame
encapsulated in Ethernet II format, 234
encapsulated in SNAP format, 234
encapsulation format, 247
receiving, 239
transmitting, 239
LLDPDU
LAN switching LLDP basic configuration, 250
LAN switching LLDP configuration, 240 , 250
LLDP basic configuration, 240
LLDP configuration, 233
LLDP parameters, 246
management address configuration, 245
management address encoding format, 245
management address TLV, 238
TLV basic management types, 235
TLV LLDP-MED types, 235
TLV organization-specific types, 235
load balancing
service loopback group
configuration,
257 , 257 , 258
load sharing
Ethernet link aggregation configuration, 41
Ethernet link aggregation group load sharing, 29
Ethernet link aggregation load sharing mode, 41
Ethernet link aggregation local-first load
sharing, 42
Ethernet link aggregation packet type-based load
sharing,
29
Ethernet link aggregation per-flow load sharing, 29
Ethernet link aggregation per-flow load sharing
algorithm settings, 43
Ethernet link aggregation per-packet load
sharing, 29
Layer 2 Ethernet link aggregation configuration, 49
local
Ethernet link aggregation local-first load
sharing, 42
Ethernet link aggregation per-flow load sharing
algorithm settings,
43
logging
loop detection configuration, 112 , 114 , 116
loop
MSTP configuration, 104
PVST configuration, 108
spanning tree configuration, 60 , 74 , 104
spanning tree loop guard, 101
loop detection
configuration, 112 , 114 , 116
displaying, 116
enable, 114
enable (global), 114
enable (port-specific), 115
interval, 113
interval setting, 116
mechanisms, 112
port status auto recovery, 114
protection action configuration, 115
protection action configuration (global), 115
protection action configuration (Layer 2 aggregate
interface), 116