H3C Technologies H3C S5560 Series Switches User Manual
Page 187
153
Step Command
Remarks
6.
Enable Layer 2
communication for ports in the
same secondary VLAN.
•
undo private-vlan isolated
•
private-vlan community
Use either command.
By default, ports in the same
secondary VLAN can
communicate with each other at
Layer 2.
This configuration takes effect
when the following conditions
exist:
•
The ports in the secondary
VLAN are configured as host
ports.
•
The secondary VLAN is
associated with a primary
VLAN.
7.
Return to system view.
quit
N/A
8.
Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
interface interface-type
interface-number
N/A
9.
Configure the uplink port as a
promiscuous or trunk
promiscuous port of the
specified VLANs.
•
Configure the uplink port as a
promiscuous port of the
specified VLAN:
port private-vlan vlan-id
promiscuous
•
Configure the uplink port as a
trunk promiscuous port of the
specified VLANs:
port private-vlan vlan-id-list
trunk promiscuous
By default, a port is not a
promiscuous or trunk promiscuous
port of any VLAN.
10.
Return to system view.
quit
N/A
11.
Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
interface interface-type
interface-number
N/A
12.
Assign the downlink port to
secondary VLANs.
a.
Set the link type of the
port:
port link-type { access |
hybrid | trunk }
b.
Assign the access port to
the specified VLAN:
port access vlan vlan-id
c.
Assign the trunk port to the
specified VLANs:
port trunk permit vlan
{ vlan-id-list | all }
d.
Assign the hybrid port to
the specified VLANs:
port hybrid vlan
vlan-id-list { tagged |
untagged }
Select substep b, c, or d depending
on the port link type.