H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 134)

17-3
Configuring an Aggregation Group Name
Follow these steps to configure a name for an aggregation group:
To do… Use the command… Remarks
Enter system view system-view ––
Configure a name for a link
aggregation group link-aggregation group agg-id
description agg-name
Required
None is configured by default.
Entering Aggregation Port Group View
In aggregation port group view, you can make configuration for all the member ports in a link
aggregation group at one time.
Follow these steps to enter aggregation port group view:
To do… Use the command… Remarks
Enter system view system-view ––
Enter aggregation port group view port-group aggregation agg-id ––
In aggregation port group view, you can configure aggregation related settings such as STP, VLAN,
QoS, GVRP, Q-in-Q, BPDU tunnel, MAC address learning, but cannot add or remove member ports.
Displaying and Maintaining Link Aggregation
To do… Use the command… Remarks
Display the local system ID display lacp system-id Available in any view
Display detailed information about link
aggregation for the specified port or
ports display link-aggregation interface
interface-type interface-number
[ to
interface-type interface-number ]
Available in any view
Display summaries for all link
aggregation groups
display link-aggregation summary Available in any view
Display detailed information about
specified or all link aggregation groups display link-aggregation verbose
[ agg-id ]
Available in any view
Clear the statistics about LACP for
specified or all ports
reset lacp statistics [ interface
interface-type interface-number [ to
interface-type interface-number ] ]
Available in user view
Link Aggregation Configuration Example
Network requirements
As shown in Figure 17-1 , AC A aggregates ports GigabitEthernet 0/0/1 through GigabitEthernet 0/0/3 to