H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 575)

61-4
z
The debugging commands are usually used by administrators in diagnosing network failure.
z
Output of the debugging information may reduce system efficiency, especially during execution of
the debugging all command.
z
After completing the debugging, you are recommended to use the undo debugging all command
to disable all the debugging functions.
z
You must configure the debugging, terminal debugging and terminal monitor commands first
to display the detailed debugging information on the terminal. For the detailed description on the
terminal debugging and terminal monitor commands, refer to the Information Center in H3C
WX6103 Access Controller Switch Interface Board Command Reference .
System Maintaining Example
Network requirements
z
The IP address of the destination device is 10.1.1.4.
z
Display the routers used while packets are forwarded from the current device to the destination
device.
Network diagram (omitted here)
Configuration procedure
<Sysname> tracert 10.1.1.4
traceroute to 10.1.1.4 30 hops max, 40 bytes packet
1 128.3.112.1 19 ms 19 ms 0 ms
2 128.32.216.1 39 ms 39 ms 19 ms
3 128.32.136.23 39 ms 40 ms 39 ms
4 128.32.168.22 39 ms 39 ms 39 ms
5 128.32.197.4 40 ms 59 ms 59 ms
6 131.119.2.5 59 ms 59 ms 59 ms
7 129.140.70.13 99 ms 99 ms 80 ms
8 129.140.71.6 139 ms 239 ms 319 ms
9 129.140.81.7 220 ms 199 ms 199 ms
10 10.1.1.4 239 ms 239 ms 239 ms
The above output shows that nine routers are used from the source to the destination device.