H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 153)

19-14
After completing the above configurations, you can use the following command to view the
configuration information of the RADIUS scheme named radsun:
<AC> display radius scheme radsun
SchemeName = radsun
Index = 0 Type = standard
Primary Auth IP = 192.168.1.1 Port = 1812 State = active
Primary Acct IP = 192.168.1.2 Port = 1813 State = active
Second Auth IP = 192.168.1.2 Port = 1812 State = active
Second Acct IP = 192.168.1.1 Port = 1813 State = active
Auth Server Encryption Key = name
Acct Server Encryption Key = money
Accounting-On packet disable, send times = 5 , interval = 3s
Interval for timeout(second) = 5
Retransmission times for timeout = 5
Interval for realtime accounting(minute) = 15
Retransmission times of realtime-accounting packet = 5
Retransmission times of stop-accounting packet = 500
Quiet-interval(min) = 5
Username format = without-domain
Data flow unit = Byte
Packet unit = one
Use the following command to view the configuration information of the ISP domain named sun:
<AC> display domain sun
Domain = sun
State = Active
Access-limit = 30
Accounting method = Required
Default authentication scheme : radius=radsun
Default authorization scheme : local
Default accounting scheme : local
Domain User Template:
Idle-cut = Disable
Self-service = Disable
Use the following command to view the port security configuration information:
<AC> display port-security interface gigabitethernet 0/0/1
Equipment port-security is enabled
Trap is disabled
Disableport Timeout: 20s
OUI value:
Index is 1, OUI value is 123401
Index is 2, OUI value is 123402
Index is 3, OUI value is 123403
Index is 4, OUI value is 123404
Index is 5, OUI value is 123405
GigabitEthernet0/0/1 is link-up
Port mode is userLoginWithOUI
NeedToKnow mode is disabled
Intrusion Protection mode is NoAction
Max MAC address number is not configured