H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 461)

50-5
z
All ports in a remote mirroring group belong to the same device. A remote source mirroring group
can have only one outbound mirroring port.
z
The outbound mirroring port cannot be a member port of the current mirroring group.
z
It is not recommended to add the source ports to a remote VLAN, which can be used for remote
mirroring only.
z
It is not recommended to configure STP, RSTP, MSTP, 802.1x, IGMP Snooping, static ARP and
MAC address learning on the outbound mirroring port; otherwise, the mirroring function may be
affected.
z
Only existing static VLANs can be configured as remote port mirroring VLANs. To remove a VLAN
operating as a remote port mirroring VLAN, you need to restore it to a normal VLAN first. A remote
port mirroring group gets invalid if the corresponding remote port mirroring VLAN is removed.
z
A port can belong to only one port mirroring group. A VLAN can be the remote port mirroring VLAN
of only one port mirroring group.
Configuring a Remote Destination Port Mirroring Group
Follow these steps to configure a remote destination port mirroring group:
To do… Use the command… Remarks
Enter system view system-view —
Create a remote destination port
mirroring group mirroring-group group-id
remote-destination
Required
Configure the remote port mirroring
VLAN for the port mirroring group mirroring-group group-id remote-probe
vlan rprobe-vlan-id
Required
In system view
mirroring-group group-id monitor-port
monitor-port-id
interface interface-type interface-number
[ mirroring-group group-id ] monitor-port
Add a port to
the port
mirroring
group as the
destination
port
In interface view
quit
Use either approach.
You can add a port to a
remote port mirroring
group as the destination
port in either system
view or interface view.
They achieve the same
purpose.
Enter destination interface view interface interface-type interface-number —
The port is an
access port
port access vlan rprobe-vlan-id
The port is a trunk
port
port trunk permit vlan rprobe-vlan-id
Add the port to
the remote
port mirroring
VLAN
The port is a
hybrid port port hybrid vlan rprobe-vlan-id { tagged |
untagged }
Perform one of these
three operations
according to the port
type.