H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 54)

6-4
z
Defining an ACL
z
Applying the ACL to control users accessing the access controller through SNMP
Prerequisites
The controlling policy against network management users is determined, including the source IP
addresses to be controlled and the controlling actions (permitting or denying).
Controlling Network Management Users by Source IP Addresses
Controlling network management users by source IP addresses is achieved by applying basic ACLs,
which are numbered from 2000 to 2999. Refer to ACL in H3C WX6103 Access Controller Switch
Interface Board Configuration Guide for information about defining an ACL.
To do… Use the command… Remarks
Enter system view system-view —
Create a basic ACL or enter basic
ACL view acl number acl-number [ name name-number ]
[ match-order { config | auto } ]
As for the acl
number
command,
the config keyword is
specified by default.
Define rules for the ACL
rule [ rule-id ] { permit | deny } [ source
{ sour-addr sour-wildcard | any } | time-range
time-name
| fragment | logging ]*
Required
Quit to system view quit —
Apply the ACL while configuring
the SNMP community name
snmp-agent community { read | write }
community-name [ mib-view view-name | acl
acl-number ]*
Required
Apply the ACL while configuring
the SNMP group name
snmp-agent group { v1 | v2c } group-name
[ read-view read-view ] [ write-view write-view ]
[ notify-view notify-view ] [ acl acl-number ]
snmp-agent group v3 group-name
[ authentication | privacy ] [ read-view
read-view
] [ write-view write-view ]
[ notify-view notify-view ] [ acl acl-number ]
Required
Apply the ACL while configuring
the SNMP user name
snmp-agent usm-user { v1 | v2c } user-name
group-name [ acl acl-number ]
snmp-agent usm-user v3 user-name
group-name [cipher ] [ authentication-mode
{ md5 | sha } auth-password [ privacy-mode
{ des56 | aes128 } priv-password ] ] [ acl
acl-number
]
Required
z
You can specify different ACLs while configuring the SNMP community name, the SNMP group
name and the SNMP user name.
z
Refer to SNMP-RMON in H3C WX6103 Access Controller Switch Interface Board Command
Reference for SNMP-related commands.