H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 242)

25-8
z
Type-1 external route
z
Type-2 external route
The intra-area and inter-area routes describe the network topology of the AS, while external routes
describe routes to destinations outside the AS.
OSPF classifies external routes into two types: Type-1 and Type-2. A Type-1 external route is an IGP
route, such as a RIP or static route, which has high credibility and whose cost is comparable with the
cost of an OSPF internal route. The cost from a router to the destination of the Type-1 external route=
the cost from the router to the corresponding ASBR+ the cost from the ASBR to the destination of the
external route.
A Type-2 external route is an EGP route, which has low credibility, so OSPF considers the cost from the
ASBR to the destination of the Type-2 external route is much bigger than the cost from the ASBR to an
OSPF internal router. Therefore, the cost from the internal router to the destination of the Type-2
external route= the cost from the ASBR to the destination of the Type-2 external route. If two routes to
the same destination have the same cost, then take the cost from the router to the ASBR into
consideration.
Classification of OSPF Networks
OSPF network types
OSPF classifies networks into four types upon the link layer protocol:
z
Broadcast: When the link layer protocol is Ethernet or FDDI, OSPF considers the network type
broadcast by default. On Broadcast networks, packets are sent to multicast addresses (such as
224.0.0.5 and 224.0.0.6).
z
NBMA (Non-Broadcast Multi-Access): When the link layer protocol is Frame Relay, ATM or X.25,
OSPF considers the network type as NBMA by default. Packets on these networks are sent to
unicast addresses.
z
P2MP (point-to-multipoint): By default, OSPF considers no link layer protocol as P2MP, which is a
conversion from other network types such as NBMA in general. On P2MP networks, packets are
sent to multicast addresses (224.0.0.5).
z
P2P (point-to-point): When the link layer protocol is PPP or HDLC, OSPF considers the network
type as P2P. On P2P networks, packets are sent to multicast addresses (224.0.0.5).
NBMA network configuration principle
Typical NBMA networks are ATM and Frame Relay networks.
You need to perform some special configuration on NBMA interfaces. Since these interfaces cannot
broadcast hello packets for neighbor location, you need to specify neighbors manually and configure
whether the neighbors have the DR election right.
An NBMA network is fully meshed, which means any two routers in the NBMA network have a direct
virtual link for communication. If direct connections are not available between some routers, the type of
interfaces associated should be configured as P2MP, or as P2P for interfaces with only one neighbor.
Differences between NBMA and P2MP networks:
z
NBMA networks are fully meshed, non-broadcast and multi access. P2MP networks are not
required to be fully meshed.
z
It is required to elect the DR and BDR on NBMA networks, while DR and BDR are not available on
P2MP networks.